Page 1 of 2.
Ford fusion door handle won t open from inside.
Diy replace 2007 ford fusion door handle driver s side handle https amzn to 36llewq passenger s side handle https amzn to 2zsayhs star b.
What have you tried so far.
Is there a diagram ava.
What is the make model year of your car.
Drivers side electric door lock and inside handle will not open door.
All other doors work properly.
When you attempt to open the door from the inside the outside door handle pulls up like you are opening the door from the outside.
I found a trick that will work while you are waiting to get the handle rep.
This is a common problem with the ford fusion 2007 to 2012 and other cars.
The doors lock properly etc.
Look for a.
Restarting the car locking and unlocking the door.
Average repair cost is 150 at 56 450 miles.
Door opens fine from outside.
If it is engaged the door will not open from the inside by design.
The 2012 ford fusion has 25 problems reported for door handle failure.
My car door will not open from the inside.
Replaced inside driver door handle for 2001 chevy prizim but the door will not open from the inside.
The 2011 ford fusion has 30 problems reported for door won t open from inside.
Must put window down and reach out side to open door.
Remove the inner door handle.
Page 1 of 2.
There will either be a screw in the center of the handle or a retaining clip on the back side of the handle.
The door handle will not allow unlocking from the inside.
Average repair cost is 190 at 72 150 miles.
Door handle issue post by tmleonard85 wed jan 04 2012 10 28 pm yup def had this happen it was raining like crazy and had to roll down my window open the door from the outside then roll up the window while getting soaked the whole time.
Remove the window crank in cars with manual windows.
A cheap piece of plastic breaks that connects the lock lever with the door handle.
The inside drivers door handle of my 2010 ford fusion is broken and it won t open.
Inside handle feel like lever broke or rod came off.
Then paid 67 42 for the handle and replaced it myself good luck.
Are you fixing your fusion yourself.
