Replace any defective parts.
Frigidaire ice dispenser door not closing.
The most common reason for replacing the door flap is if it does not open to.
If the dispenser door motor is defective the dispenser door won t open.
As a result the di spenser will not dispense ice.
If your refrigerator is not dispensing water simply check the following.
If the auger is not properly aligned the refrigerator will not dispense ice and or the door may not close properly.
This video provides step by step instructions for replacing the ice dispenser door flap on whirlpool refrigerators.
So when you open the freezer door the crushed ice falls to the floor.
What should i do if the dispenser on my refrigerator is not dispensing water.
The ice maker would not stop dispensing crushed ice even without pressing the actuator on the exterior.
If the auger motor and dispenser door are not receiving power then you should inspect the actuator and switch.
If the door is not closing properly it can create the ice and frost build up you have.
Ice dispenser door seal frigidaire 241688701 this part works in conjunction with the ice chute door.
Genuine original equipment manufacturer oem parts.
Dispenser ice chute door kit 241688401 opens to let ice through when dispensing into a glass or other container.
The door on the ice dispenser doesn t automatically close after ice is dispensed can move the lever that you press to dispense ice forward and it.
Refer to your parts diagram for a complete list of parts included.
The dispenser door motor opens and closes the dispenser door to prevent cold air from escaping the freezer.
This dispenser ice chute door kit part number 241688401 is for refrigerators.
Its actually not even really dispensing its building up crushed ice in the door hopper.
If it doesn t look up the ice shoot to see if the flapper is opening.
To determine if the motor is defective first determine if the motor is getting power.
The flapper might not be shutting properly and this will allow air in causing a huge block of ice to form inside the dispenser and ice bin.
Remove the control panel cover and verify that the actuator contacts the dispenser switch properly and if not check the actuator housing bracket switch mounting bracket and the actuator pivot.
