Charlie october 29th 2011 at 3 38 pm.
Hayward chlorinator lid leaking.
July 9 2016 september 3 2016 ask the pool guy.
My hayward chlorinator lid with the black top is leaking.
Cl220 remove the lid and disconnect the black tubing from the plumbing lines.
Replaces part no 308 1125 spx1500p 47 0354 07 r 004036 303420 53 159 354533 2921141215 o231 35505 7430 o rings.
The first time it was under warranty so it was replaced with a.
Replace worn out o rings to maintain a good seal on the lid of your hayward chlorinator.
I haven t been able to get an answer any where.
If a chlorinator lid begins to leak there are a couple of things to check.
My hayward chlorinator cl200 is also leaking out of the top.
It also has a flow control valve that allows you to adjust the flow of water.
Using this valve you can regulate the flow of the water through the chlorinator if the chlorine level in the pool rises too high or falls too low.
We just replaced o ring 4 weeks ago after it was leaking from the bottom.
The process is similar for a rainbow chlorinator as well.
Hayward chlorinator lid o ring clx200k 2 on schematic o ring for the lid of hayward chlorinator feeder clx200k.
Check the o ring and the top of the canister where the top screws on to make sure it is clean and not gunked up or out of place or broken.
One of the most common o rings that will leak on both the cl220 and the cl110 hayward chlorinators is the top cover gasket as shown in part number 6 in the diagram.
Ensure that the water is drained and then store for the winter.
Each hayward chlorinator has a removable lid that allows you to drop in a slow release trichlor chlorine tablet.
Consult your chemical manufacturer for the required disposal procedures.
I have replaced the o ring but it still leaks.
My cl220 hayward off line chlorinator has broken the cover cap lid two times in two years.
This part is called the hayward chlorinator cover replacement o ring if you should decide to buy the part at a local pool supply store such as leslies or even online.
Next remove the lid and properly dispose of any chlorine inside the chlorinator.
Ensure the feeder has been drained of all water.
I have noticed that the top goes past the lid lock and the top can t go any farther.
